Metrohm 757 VA Computrace Manual do Utilizador descarregar pdf (Página 110)

5 Determination mode

757 VA Computrace – Software

100

Auto scaling

DETERMINATION CURVES

/ Plot / Auto scale (F4)

Reset zooming and scale x and y axes so that all

measurement points of all determination curves

are visible.

Swap axis

DETERMINATION CURVES

/ Plot / Swap axis / abscissa

Swap x axis for the current determination curve.

DETERMINATION CURVES

/ Plot / Swap axis / ordinate

Swap y axis for the current determination curve.

Show baselines

DETERMINATION CURVES

/ Plot / Show baselines

If this option is enabled, the calculated baselines

are displayed in the determination curves sub-

window.

Show unknown peaks

DETERMINATION CURVES

/ Plot / Show Unknown peaks

If this option is enabled, all peaks found but not

assigned to a defined substance are marked in

the determination curves subwindow with "

Unk

Graphical properties for determination curves

As default, the axes displayed in the determination curve subwin-

dow have the following orientation:

x axis The determination curves are displayed from the

left to the right (for anodic sweeps: from – to +;

for cathodic sweeps: from + to –). For cyclic

sweeps, the forward sweep is displayed from the

left to the right.

y axis The y axis is always displayed from the bottom to

the top with the same direction as the x axis (for

anodic sweeps: from – to +; for cathodic

sweeps: from + to –).

The following graphical properties for curves in the determination

curves subwindow can be set:

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 197 198

Comentários a estes Manuais

Sem comentários

Metrohm 757 VA Computrace Manual do Utilizador Página 110

Comentários a estes Manuais

Manuais e produtos relacionados com Software Metrohm 757 VA Computrace