Metrohm 874 USB Oven Sample Processor Manual do Utilizador descarregar pdf (Página 42)

3.16 Connecting USB devices

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭

￭￭￭￭￭￭￭￭

874 Oven Sample Processor

box also has an MSB socket at which a further MSB instrument, e.g. a

dosing device or a stirrer, can be connected.

You will find precise information concerning the pin assignment of the

interface on the remote box in Appendix (see Chapter 7.1, page 40).

3.16 Connecting USB devices

Two USB connectors (Type A sockets) are available for connecting devices

with USB interfaces. The 874 Oven Sample Processor functions then as a

USB hub (distributor). If you wish to connect more than two USB devices,

you can also use an additional commercially available USB hub.

Note

When a USB device is connected, the control instrument recognizes

which device is connected. The control software automatically enters a

connected USB device into the system configuration (Device manager).

3.16.1 Connecting a barcode reader

A barcode reader is used as an input aid for entering text and numbers.

You can connect a barcode reader to a USB interface.

Connect a barcode reader as follows:

Connecting the cable

￭ Plug the USB plug (Type A) of the barcode reader into one of the

USB sockets on the rear side of the instrument.

USB 2

USB 1

Figure 23 USB connectors

Configuring the barcode reader in the control software

￭ Configure the barcode reader in the configuration part of the

control software as described in the online Software Help.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 78 79

Sem comentários

Metrohm 874 USB Oven Sample Processor Manual do Utilizador Página 42